PCD Compression | THINK PCD COMPRESSION | Brochure List | | 
| 68-100 SERIES Longer Tool Life | Clean Edge Finish | Reduced Tooling Cost | Resharpenable | | | Onsrud is now offering a line of PCD (Polycrystalline Diamond) compression cutting tools for difficult to cut materials. The high-speed-steel body results in a durable tool while the PCD cutting edges greatly increase life resulting in increased productivity by the elimination of frequent tool changes. . | Onsrud?s single-edge offering will range from 3/8" to 3/4" diameters. The tool?s PCD mortise tip also results in long life when plunge cutting. The compression design will ensure you get a chip-free edge both top and bottom. . Tools can be serviced but the economical design is an attractive alternative to more expensive tools. . Usage: Composite Wood, Melamine Sheet, Laminated Sheet, Other Difficult to Cut Materials. | PRODUCT OFFERING PART # | CED | CEL | UPCUT CEL | SHANK | OAL | FLUTES | 68-100 | 3/8 | 1 | 0.188 | 1/2 | 3 | 1 | 68-100L | 3/8 | 1 | 0.188 | 1/2 | 3 | 1 | 68-1-2 | 1/2 | 1 | 0.200 | 1/2 | 3 | 1 | 68-102L | 1/2 | 1 | 0.200 | 1/2 | 3 | 1 | 68-104 | 5/8 | 1 | 0.200 | 5/8 | 3-1/2 | 1 | 68-104L | 5/8 | 1 | 0.200 | 5/8 | 3-1/2 | 1 | 68-110 | 5/8 | 1-5/8 | 0.200 | 5/8 | 4 | 1 | 68-110L | 5/8 | 1-5/8 | 0.200 | 5/8 | 4 | 1 | 68-106 | 3/4 | 1 | 0.200 | 3/4 | 4 | 1 | 68-106L | 3/4 | 1 | 0.200 | 3/4 | 4 | 1 | 68-112 | 3/4 | 1-5/8 | 0.200 | 3/4 | 4 | 1 | 68-112L | 3/4 | 1-5/8 | 0.200 | 3/4 | 4 | 1 |
L = Left Hand Rotation * = Tools are not stocked and must be special ordered. Approximately 4 week lead time. |
|
| | | | |
|
|
|
|
Enter your email address
to receive discounts. |
|
|
|
|
|
|
|
|
|
